温控箱产品说明:

1、控制电路采用PID智能控制，线性输出，可以延长发热体和锡锅使用寿命。

2、控制部份采用微电脑芯片控制，温度准确波动小。

3、具有故障提示和超温提醒功能，使操作员能及时发现故障。

4、采用封闭轻触式开关，操作方便。 相关参数： 1、 电压：AC 85-240V； 2、 工作温度：0—55度； 3、 工作湿度：≤90%RH无结露； 4、 温度范围：0-600℃； 5、 控制精度：±5℃LEAD-FREE TITANIUM ALLOY SOLDERING POTOperation instructionWARNING:FEATURES:* With big power heater, only within 25minutes to reach 450℃from room temperature, (Different items with a little different heating time.)* With advanced microcomputer digital control and double displays. make it more accurate heating and fast temperature returning capability.* The boiler made of titanium alloy, can resist high temperature, cauterization and abrasion, largely prolong the life.* The setting value will be saved for long time, and can not be affected by power on or off. With auto sleeping function, prolong the machine’s life.Working conditions:Working voltage: AC110±10VWorking temperature: 0-55℃Working temperature: < 90% no dewOPERATION1.Temperature set:①Turn on the power switch, press the“△” or“▽” button directly to adjust the temperature. Press the“△” or“▽” button once, the temperature will go up or down by one unit. Keep pressing the“△” or“▽” button, the temperature will keep going up or down. The temperature value will be saved just in two seconds after you set, without the impact of turning off or power off.   ②Turn on the power switch, use “*” button to control the point position and adjust the temperature. When the point stop after a number, you can use“△” or“▽” button to adjust this value. The temperature will be saved in two seconds without the impact of turning off or power off. 2. Microcomputer self-adjustingIf the temperature is fluctuating or has some discrepancy from the real temperature, you need just to keep pressing “ *”button. If you want to quit from the self-adjusting status, you can also keep pressing this button.Remark: Usually it takes about 30 minutes to finish this adjusting, during this the temperature will fluctuate obviously, but it’s no wonder.3．Calibration between displayed and real temperature:After self-adjusting, if the displayed temperature has obvious discrepancy from the real temperature, you can use the following two ways to calibrate. ①Keep pressing “CAL” button for two seconds, adjusting the left LED until it display “Ctrl”, and Adjusting the right LED until it display “1”, then repeat the operation of microcomputer self-adjusting 2.②Keep pressing “CAL” button for two seconds, then, press it again, the left LED will display “SC”, after the calibration, press “CAL” button to save and quit.For example: the displayed temperature is 10 degrees higher than the real temperature, you can use“▽” button to adjust to “-10”, then press “CAL” button to save and quit. In the opposite, the displayed temperature is 10 degrees lower than the real temperature, you can use“△” button to adjust to “10”, then press “CAL” to save and quit.4．Notes:During self-adjusting, the other parameters can not be adjustedSelf-adjusting take 20-40 minutes, after self-adjusting, it also need 10-20 minutes to keep stable, during all this process, the temperature will fluctuate obviously, but it’s no wonder.Failure testing1.turn on the power switch without electricity. the power switch light is bright, the heating light is not bright, that is the damage of heating unit.