FSP460-601U SPECIFICATIONS
- Input Voltage: 100~240VAC full range
- Input Frequency: 47~63Hz
- Input Current: 9A max. 115Vrms at 60Hz; 5A max. 230Vrms at 50Hz
- Inrush Current: 80A Max for 115V AV, 120A Max for 230V AC Cold Start
- Hold Up Time: 18ms min. at full load & norminal input voltage
- Output Power: +5V and +3.3V total output shall not exceed 200W
+3.3V, +5V, and +12V total output cannot exceed 440W
-5V and -12V total output not exceed 10W - Power Good Signal: Turn on delay 100~500ms, off delay 1ms minimum (TTL and CMOS compatible)
- Efficiency: 65% min. at full load
- Protection Over Voltage: +5V output 6.5V max.; +3.3V output 4.5V max.; +12Vdc output 15.6V max.
- Over Load: 150% max.
- Short Circuit: All Outputs
- Thermal System: One Internal 12V DC 8cm ball bearing cooling fan
- Temperature: Operating: 0~50°C
Storage: -20~+80°C - Temperature Coefficient: 0.01% per °C
- Humidity: 5~95% RH
- Dimensions: 106 x 40.5 x 300 cm
- MTBF: 100K hrs. at 25°C
- Safety: UL 1950, CSA C22.2 Level 3, TUV EN60950, NEMKO EN60950 (CB Report), CE
Output Specification
Output Voltage | Min. Load | Max. Load | Load Regulation | Line Regulation | Ripple & Noise |
+3.3V | 0.5A | 30.0A | +/- 5% | +/- 1% | 50mV |
+5V | 0.5A | 30A | +/- 5% | +/- 1% | 50mV |
+12V | 2.0A | 32A | +/- 5% | +/- 1% | 120mV |
-5V | 0A | 0.3A | +/- 10% | +/- 2% | 120mV |
+5Vsb | 0A | 2A | +/- 5% | +/- 1% | 50mV |
-12V | 0A | 0.8A | +9%/-5% | +/- 2% |
Specification
Temperature Range:Operating 0° C ~ 50° C; storage & shipping -20° C ~ 80° C
Temperature Coefficient:0.01% / ° C
Transient Response:Output voltage returns in less than 1 ms max. at a 25% load change
Hold-up Time:16ms minimum at full load & nominal input voltage
Dielectric Withstand:Input to frame ground 1800 VAC for 1 second
Humidity:95% RH
Efficiency:63% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
Power Good Signal:Power on delay time 100 ms to 500 ms, off delay 1 ms minimum
Overload Protection:150% Max.
Maximum power:460W ( +5V and +3.3V total output not exceed 200W, 3.3V &+5V &+12V total output not exceed 440W )
Dimensions (WxHxL):106x40x300(mm)/4.17”x1.57”x11.8”
Features
High efficiency
Active PFC circuit
Power factor correction (PFC)>0.95@100VAC
Internal 12 VDC fan included
Low noise and ripple
Complies with FCC part 15 subpart J class B 115VAC operation and CISPR 22 class B 230 VAC operation
Output over voltage protection
Short circuit protection on all outputs
MTBF above 100,000 hrs. at 25° C
100% Hi-pot & ATE tested
Short circuit protection on all outputs
Resettable power shut down
100% burn-in under high ambient temp. (50° C)
Approved by UL 1950, CSA C22.2 Level 3, IEC 950, VDE 60950, TUV EN60950, CE
