Protocol & Hierarchy	DP-V0 Slave
Supports PROFIBUS Transmission Rate (kbps)	9.6, 19.2, 45.45, 93.75, 187.5, 500, 1500, 3000, 6000, 12000
Transmission Rate Setting	detected automatically
Max Input Data Length	240 Bytes
Max Output Data Length	240 Bytes
Address Setting	0~126 set by DIP switch or EEPROM
Supports HART Mode	point-to-point / multi-drop
Support HART Master	Allow two HART Masters
Support HART Channel	4 channels
Support HART Frame	Short/Long frame
Support HART modules	Connecting up to 15 HART modules
Support HART Burst mode	YES
Indicators	PWR, ERR, and RUN LEDs
Network Isolation Protection	2500 Vrms High Speed iCoupler
DC Isolation Protection	3000 VDC on PROFIBUS side

Hardware
CPU	80186, 80 MHz or compatible
SRAM/Flash/EEPROM	512 KB / 512 KB / 16 KB
Watchdog	Watchdog IC CPU built-in
ESD Protection	4 kV class A
PROFIBUS Interface
Controller	Profichip VPC3+C
Transceiver	ADI ADM2486
Connector	9-pin female D-Sub
Baud Rate (bps)	9.6 k, 19.2 k, 45.45 k, 93.75 k, 187.5 k, 500 k, 1.5 M, 3 M, 6 M, 12 M
Transmission Distance (m)	Depend on baud rate (for example, max. 1200 m at 9.6 kbps )
Isolation	3000 VDC for DC-to-DC, 2500 Vrms for bus-to-logic
Protocol	DP-V0
HART Interface
HART Interface	8-pin screwed terminal block
HART Channel	4 channels
UART Interface
COM	RS-232
COM Connector	3-pin screwed terminal block (RxD, TxD, GND)
Baud Rate (bps)	Up to 115200
Data bit	7, 8
Stop bit	1, 2
Parity	None, Even, Odd
LED
Round LED	PWR LED, RUN LED, ERR LED
POWER
Power supply	Unregulated +10 ~ +30 VDC
Protection	Power reverse polarity protection, Over-voltage brown-out protection
Power Consumption	2.0 W
Mechanism
Installation	DIN-Rail
Dimensions	72 mm x 33 mm x 119 mm (W x L x H)
Environment
Operating Temp.	-25 ~ 75℃
Storage Temp.	-30 ~ 85℃
Humidity	5 ~ 95% RH, non-condensing