齿轮马达配蜗轮蜗杆传动装置，标准马达Φ63，120W输出12/24V，3000/min负载情况下，并带有电子消声器。传动轴安装在轴承套上，输出轴由两个轴承和挡油板支撑，并安装在输出口处。
﹡转速变动范围可以有±10%
﹡连接的2根线0.75×250mm
S1在负载测试使用5A电流时温度增加到70℃
S2在负载测试使用11.5A电流时5分钟开，5分钟关温度最高升至80℃
初始电流5A和不能维持超过2秒，
输出轴最大承载能力：轴向25KG，径向40KG
型号Type
| 减速比Ratio
| L
mm | * 空载转速R.P.M. no load
min-1 | * 转速R.P.M. S1
min-1 | 扭矩S1 Torque
Nm | * 转速R.P.M. S2
min-1 | 扭矩S2 Torque
Nm | 最大扭矩Max Torque
Nm | I max
A |
| MVSF 763 L 26 1/10 | 10.5 | 185 | 250 | 200 | 2 | 160 | 3.8 | 10 | 22 |
| MVSF 763 L 26 1/20 | 21 | 185 | 124 | 100 | 3.70 | 82 | 7.20 | 14 | 22 |
| MVSF 763 L 26 1/30 | 31 | 185 | 85 | 74 | 4.10 | 63 | 8.5 | 17 | 22 |
| MVSF 763 L 26 1/40 | 39 | 185 | 64 | 50 | 4.50 | 38 | 9.2 | 19 | 22 |
Gear motor with worm screw and standard motor Ø 52 12/24 Vdc 2000 RPM output 45W, with noise suppressor.
Starting corrent 6 A.
Driving shaft mounted on two bearing Outlet shaft supported by two bearings.
Design to give low RPM in little dimension.
* The rotation speed can change of ±10%.
The S1 load test was made using a corrent in the air with an increase of temperature of 70 C°.
The S2 load test was made using a corrent in the air with a 50% timing 5’ with an increase of temperature
of 80 C° max.
The starting corrent (I max) cannot be maintained for more than 2".
Max forces wich may act on the outlet shaft: Axial 30 kg, Radial 40 kg.
It is possible to apply an encoder
