齿轮马达配蜗轮蜗杆传动装置，标准马达Φ52，45W输出12/24V，2000/min负载情况下，并带有电子消声器。传动轴安装在轴承套上，输出轴由两个轴承和挡油板支撑，并安装在输出口处。

﹡转速变动范围可以有±10%

﹡连接的2根线0.75×250mm

 

S1在负载测试使用1.8A电流时温度增加到70℃

S2在负载测试使用2.9A电流时5分钟开，5分钟关温度最高升至80℃

 

初始电流5A和不能维持超过2秒，

输出轴最大承载能力：轴向25KG，径向40KG

详细： 

  

型号Type	减速比Ratio	* 空载转速      R.P.M. no load min-1	* 转速R.P.M. S1 min-1	扭矩S1 Torque Nm	* 转速R.P.M. S2 min-1	扭矩S2 Torque Nm	最大扭矩Max Torque Nm	I max A
752 26 1/10	10,5	190	165	1,2	118	2	4,5	6
752 26 1/15	15,5	130	115	1,6	75	2,8	5,8	6
752 26 1/20	21	95	78	2,4	57	3,5	7,6	6
752 26 1/30	31	65	51	3,2	37	5	7,5	6
752 26 1/40	39	50	38	3,6	28	8	13,3	6

Gear motor with worm screw and standard motor Ø 52 12/24 Vdc 2000 RPM output 45W, with noise suppressor.
Starting corrent 6 A.
Driving shaft mounted on two bearing Outlet shaft supported by two bearings.
Design to give low RPM in little dimension.
* The rotation speed can change of ±10%.
The S1 load test was made using a corrent in the air with an increase of temperature of 70 C°.
The S2 load test was made using a corrent in the air with a 50% timing 5’ with an increase of temperature
of 80 C° max.
The starting corrent (I max) cannot be maintained for more than 2".
Max forces wich may act on the outlet shaft: Axial 30 kg, Radial 40 kg.
It is possible to apply an encoder