E27灯头焊锡高度规

E27灯头焊锡高度规  (7006-27C-1) 中英文使用说明

目的：用来检测E27灯头的尺寸S1的最大值和最小值（即焊锡高度）。

使用方法：将成品灯上的灯头插入量规时，量规柱塞端面W应与量规的X面共面或凸出于X面，但不能高于Y面。

“GO” GAUGE FOR DIMENSION “S1” OF E27 CAPS ON FINISHED LAMPS

Purpose: To check the dimensions S1 minimum and S1 maximum of E27 caps on finished lamps shown on sheet 7004-21

Testing: When the cap on a finished lamp has been pushed into the gauge as far as it will go ,the plunger surface “W” shall be co-planar with or project beyond surface “X” but it shall not project beyond surface “Y”

E27螺口灯头接触性能量规

E27灯头接触性能规  (7006-50-1)使用说明

目 的：用来检测灯与IEC标准灯座的接触性能

使用方法：将被测试灯推入量规，能直至W面接触到V面或者超过V面，则表示接触性能良好。否则不符合要求。

GAUGE  FOR FINISHED LAMPS FITTED WITH E27 CAPS FOR TESTING CONTACT MAKING

Purpose : To check lamp dimensions for contact making in I.E.C. holders

Testing: The shape of the lamp with regard to the fit in the lampholder is assumed be correct , if the lamp can be pushed into the gauge till plane W reaches plane V or projects beyond it