1.基本规格及性能Basic Specification and Performance
1.1 容量 Capacity | 标称容量Rated Capacity:2000mAh(0.2CA放电 Discharge) 最小容量Capacity(min):1950mAh(0.5CA放电Discharge) |
1.2 标称电压 Rated Voltage | 3.7V |
1.3 电池内阻Internal Resistant | ≤70mΩ (with PTC) |
1.4 放电终止电压Discharge End Voltage | 2.75V |
1.5 充电上限电压Charge Upper Limit Voltage | 4.20±0.02V |
1.6 标准充电电流Standard Charge Circuit | 0.5C A |
1.7 快速充电电流Fast Charge Circuit | 1C A |
1.8 标准放电电流Standard Discharge Circuit | 0.5C A |
1.9 快速放电电流Fast Discharge Circuit | 1C A |
1.10 最大放电电流Discharge Circuit (max) | 2C A |
1.11 电池重量Weight | 45±1g |
1.12 最大尺寸Dimension(max) | 直径(φ) : 18.3mm 高度(H) : 65.0mm (参见附图1) (see figure 1) |
1.13 工作温度Operational Temperature | 充电charge :0 ~ 45℃; 放电discharge :-20 ~ 60℃ |
1.14 贮存温度Storage Temperature | 1个月内within a month :-5 ~ 35℃ 6个月内within six months :0 ~ 35℃ |
2.测试条件
实验和测量要在标准温度(20±5℃)及标准湿度(65±20%)的条件下进行。
Please perform under this condition:
Standard temperature: (20±5℃), standard relative humidity: (65±20%)
2.1标准充电 Standard Charge | 恒流恒压充电(CC/CV) constant circuit and constant voltage charge 恒流constant circuit :1000mA 上限电压upper limit voltage:4.20V 截止电流end circuit:20mA |
2.2标准放电 Standard Discharge | 恒流放电(CC) constant voltage discharge 恒流constant circuit :1000mA 终止电压end voltage:2.75V |
3.外观Appearance
外表清洁,无机械损伤、漏液、锈蚀;另表面有必须的产品标识。
The battery should be clean and dry, no technical damages , electrolyte leakage, rustiness,
and with product identification on the surface.
4.性能Performance
4.1 电性能Electrical Performance
项目Items | 测试程序Testing Procedure | 标准Requirements |
4.1.1标称电压Rated Voltage | 电池按6.1充电后,按6.2放电过程的平均工作电压 Charge according to 6.1, then calculate the average voltage during discharge process according to 6.2 | 3.7V |
4.1.2放电性能Discharge Performance | 电池按6.1充电后1小时内以0.5CA恒流放电到2.75V Charge according to 6.1, then discharge within 1 hour with constant circuit of 0.5CA to the end voltage is 2.75V | ≥120min |
电池按6.1充电后1小时内以1.0CA恒流放电到2.75V Charge according to 6.1, then discharge within 1 hour with constant circuit of 1.0CA to the end voltage is 2.75V | ≥57min | |
4.1.3循环寿命Cycling Life | 在环境温度20±5℃的条件下,以0.5CA先恒流充电至上限电压,再恒压充电至充电电流≤20mA;搁置0.5h后以0.5CA放电至2.75V,放电结束后搁置0.5-1h后进行下一个循环,直至连续两次放电时间小于72min,则认为寿命终止。 Under the ambient temperature of 20±5℃,charge with a constant circuit of0.5CA to upper limit voltage, then charge with constant voltage till the circuit is no more than 20mA; lay the battery aside for 0.5 hour, then discharge with 0.5CA till the end voltage is 2.75V; lay the battery aside for 0.5-1 hour before next cycle; when the discharge time of the consecutive discharge is both lower than 72 minutes, the cycle life is over. | ≥500次Times |
4.1.4荷电保持能力 Capacity Holding | 按6.1充电,在温度20±5℃的环境下放置28天,然后以0.2CA放电至2.75V,电池放电容量≥90%标称容量。 Charge according to 6.1, lay the battery aside for 28 days in the ambient temperature of 20±5℃,then discharge with0.2CA till the end voltage 2.75V appears, the capacity given out should be no less than 90% of the rated capacity. | 容量Capacity≥1800mAh |
4.1.5存贮Storage
| 自生产日期到测试日期不足3个月的电池按6.1充电方式充入40%-50%的容量,然后在环境温度20±5℃,相对湿度45%-85%的环境中存贮12个月,存贮期满后按6.1充满电,0.2CA放电至2.75V。 As for the battery life less than 3 months, charge into 40-50% of the rated capacity according to 6.1, then store for 12 months under a condition of ambient temperature of 20±5℃and 45%-85% RH; after storage, charge according to 6.1, then discharge with0.2CA till the end voltage is 2.75V. | 放电时间Discharge Time≥4h. |