VOLTAGE： 90～264VAC FULL RANGE FREQUENCY： 47～63HZ INPUT CURRENT：9A/4A (115 / 230 VAC) POWER MODULE INRUSH CURRENT：35A/70A MAX. FOR 115/230 VAC POWER MODULE
Output Voltage
Output Current Min.
Output Current Max.
Output Current Peak
Regulation Load
Regulation Line
Output Ripple & Noise Max.[P-P]
+5V
1
32.00
±5%
±1%
50mV
+12V
3
88
±5%
±1%
120mV
-12V
0.1
1.2
±5%
±1%
150mV
+3.3V
1
32
±5%
±1%
50mV
+5VSB
0.3
4
±5%
±1%
50mV
TOTAL CURRENT OF +5V AND +3.3V NOT EXCEED 190W TOTAL OUTPUT MAX: 1140W
* TEMPERATURE RANGE：OPERATING 0℃～40℃ * HOLD UP TIME：16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE * DIELECTRIC WITHSTAND：INPUT/OUTPUT 1500 VAC FOR 60 SECOND INPUT TO frame GROUND 1500 VAC FOR 60 SECOND * EFFICIENCY：82% TYPICAL AT 115VAC, FULL LOAD * POWER GOOD SIGNAL：ON DELAY 100mS TO 500mS * OVER POWER PROTECTION：110% ~ 180% * OVER VOLTAGE PROTECTION：+5V→5.9V～6.7V、+12V→13.0V～15.0V、+3.3V→3.9V～4.3V SHORT CIRCUIT PROTECTION：SHUT DOWN AND LATCH OFF * EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B * SAFETY: TO MEET UL, CUL, TUV, CCC * REMOTE ON/OFF CONTROL THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY). AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE， AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE. * N+1 REDUNDANCY FUNCTION * HOT-SWAPPABLE FUNCTION * CURRENT/BALANCE LOAD SHARING DESIGN * +3.3V REMOTE SENSING * ISOLATION: BUILT-IN IN POWER MODULE * POWER FACTOR CORRENTION: ACTIVE (MEET IEC-1000-3-2) * COOLING: 40mm DC FANS (one module)
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
