专业生产锂电池和铅酸电池充电器。详情请联系卖家。
1、描述(SCOPE):
本规格书适用于DSS-168100型号的充电器。
The purpose of the document is to specify the functional requirements of a 16.8W switching power supply.
2、输入特性(INPUT CHARACTERISTICS):
2.1输入电压(Input Voltage):
额定电压(Nominal Voltage):100-240VAC
调整范围(Variation Range):90-264VAC
2.2输入频率(Input Frequency):
额定频率(Nominal Frequency):50/60Hz
调整频率(Variation Frequency):47-63Hz
2.3输入电流(Input Current):
当输入交流电压为额定值的下限时,输出电压负载满载,最大输入交流电流1A。
1Arms max At any input voltage and rated, DC output rated load.
2.4浪涌电流(Inrush Current):
当输出为额定负载,环境温度为28℃,输入240VAC冷态起动电源时的最大浪涌电流小于10A。
10Amps Max. Cold start at 240VAC input, with rated load and 28℃ambient.
2.5 AC漏电流(ACLeakage Current):
当输入电压240VAC时,最大漏电流为0.25mA。
0.25mA Max At 240VAC input.
3、输出特性(OUTPUT CHARACTERISTICS):
3.1输出功率(Power Output);
电压 最小负载 最大负载 峰值功率 输出功率
Voltage Min. Load Max. Load Peak Output Power
16.8VDC 0A 0.9-1.1A 17.2W 16.8W
3.2负载特性/调整率(Combined Load/Line Regulation):
电压 最小空载电压 最大空载电压 线性调整 负载调整
Voltage Min. Voltage Max. Voltage Line Regulation Load Regulation
16.8VDC 16.8V 16.95V ±3% ±5%
3.3波纹和噪音(Ripple And Noise):
测试条件:任何负载正常工作下,使用示波器带宽为20MHz连接到充电器的输出端,同时输出端并连一个4.7uF的电解电容和一个104的瓷片电容。
The ripple and noise are as follows when measure with Max. Bandwidth of 20MHz and Parallel 4.7uF/0.1uF,crossed connected at testing point.
电压 最大波纹最大噪音
Voltage Ripple And Noise(Max.)
+16.8VDC 160mVp-p
3.4启动延迟时间(Turn On Delay Time):
当输入115VAC和输出最大负载时,最大启动时间为1.5S。
1.5second Max. At 115VAC input and output Max. Load.
3.5上升时间(Rise Time):
当输入115VAC和输出最大负载时最大时间为40mS。
40mS Max. At 115VAC input and output Max. Load.
3.6保持时间(Hold Up Time):
当输入115V和输出最大负载时,最小保持时间为5mS。
5mS Min. At 115VAC input and output Max. Load.
3.7效率(Efficiency):
当输入100VAC和输出最大负载时,最小80%。
80%Min.At 100VAC input and output Max. Load.
当输入240VAC和输出最大负载时,最小82%。
82%Min.At 240VAC input and output Max. Load.
3.8电源LED指示:空载充电器LED指示灯亮绿灯,接上电池充电时LED指示灯亮红灯,当电池充满电的时候LED由红灯自动转换成绿灯。
4、保护功能(PROTECTION REQUIREMENT):
4.1短路电路保护:
Short Circuit Protection:
该电源供给器在短路解除时,能正常工作恢复。
The power supply will be auto recovered when short circuit faults remove.
4.2过流保护(Over current Protection):过流故障排除后,电源将自动恢复正常工作。
The power supply will be auto recovered when over current faults remove.
4.3充满电池的转灯的时候电流为:80—160mA