液位液位控制器使用说明书

Key liquid level controller instructions

一：安装及接线方法Installation and wiring method

二、

 使用“红色”和“白色”的电线，浮球在下水位时，接点是接通的状态，浮球在上水位时，接点是不通的状态

 使用“红色”和“蓝色”的电线， 浮球在上水位时，接点是接通的状态，浮球在下水位时，接点是不通的状态

未使用的电线必须予以绝对绝缘

The use of" red" and" white" wires, the floating ball in the water level, contact is connected to the state,

The floating ball in the water level, contact is blocked state

The use of" red" and" blue" wires, the floating ball in the water level, contact is connected to the state,

The floating ball in the water level, contact is blocked state

三：The weight of the device method

The hammer on the nut loose, will float switch wires from the weight of the center hole is penetrated by a screw cap, gently push the weight, by wire head thrust through the. Then the weight onto you want to set the water level. Then tighten the nut,

Please pull wire directly to the control box, to avoid the use of intermediate joint, if forced a connector, cable connector will not be immersed in water.

重锤的装置法：

1.先将重锤上的螺帽拧松，将浮球开关的电线从重锤的中心螺帽圆孔处穿入后，轻轻推动重锤，因电线头之推力而穿过。再将重锤推到您想设定之水位。然后再拧紧螺帽，

请将电线直接拉到控制箱，尽量避免使用中间接头，若不得已而有接头时，绝不可将电缆线接头浸入水中。