BURNS 100 TIMES LONGER THAN NORMAL TORCHES 100,000 HOURS OF LED LIFE(NO NEED TO REPLACE LED AGAIN).300 HOURS OF PLEASANT LIGHTWITH RECHARGEABLE FUNCTION.POWERED BY 33 PCS OF ULTRABRIGHT MULTIPLECHIP LED WHICH ACTS AS LED TORCH LIGHTALSO POWERED BY ADJUSTABLE SLIDING GLASS COVER WHICH MAKES IT WORK AS EMERGENCY LIGHT & ALSO AS NORMAL TORCH.INCREASED DISCHARGE TIME DUE TO TRIPPLE FUNCTION MODE.STRONG ABS BODY.WATER RESISTANT AND SHOCK PROOF.USING HIGH CAPACITY 4V 1200MAH SEALED LEAD ACID BATTERY, MORE PRACTICAL THAN ALKALINE BETTERY.MORE ENVIRONMENT FRIENDLY.1. OFF is in the middle of the handle. When pushing the ON/OFF button upwards till it touches the upper end, 5LED is lighting; pushing the ON/OFF button further downwards, the 28LED burns; pushing the ON/OFF button further downwards till it touches the lower end, the 33LED all is bright.2.To change the focus light so as to make it work as a torch, please push the adjustable glass cover upwards till it touches the upper end. To change focus of the light so as to make it work as normal emergency light, please push the adjustable glass cover downwards till it touches the lower end. Please note that the focus of the light can be changed from torch to emergency light in all the 3 modes mentioned above.3.To charge the torch light, just open the plastic cover at the base of the torch light & unwind the charging wire. Plug the 220 V pin in any standard AC outlet which in turn will charge the LED torch light.4.There is a small indicator near the brightness control knob, indicating the status of the charge. Once fully charged unplug the wire from the AC outlet and wind it again and place it under the base of LED torch light with plastic cover on top.5.Avoid looking directly into the Led’s as it has a strong beam.6.Charge the torch light only in OFF position or else it may damage the LEDs.比传统电筒寿命长一百倍。十万小时以上的LED寿命（无须更换LED）。三百小时以上的照明时间。可充电功能。LED电筒带33个高亮度的LED灯。还带有可调节的聚光灯板，作为应急灯使用，也可作普通电筒。三种功能模式。ABS外壳。防水，防震。使用内置高容量4V 1200mAH铅酸蓄电池，比使用碱性电池更实用。更环保。
1.手把上开关的中间位置是 关 。当往最前位置推动开关时，5个LED灯亮了；往后推动两个档位时，28个LED灯亮了；继续再往后推动一个档位至最后位置时，33个LED灯全部亮了。
2.要转换成电筒使用时，请推动可移动的聚光灯板到最上面的尽头。要转换成应急灯使用时，请推动可移动的聚光灯板到最下方尽头。请注意灯的聚光可以由电筒与应急灯之间相互转换更改，如上所述三种模式。
3.给电筒充电时，只要打开电筒底部的塑料盖子，取出电源线。插在标准AC 220V的插座上，就能给电筒充电了。
4.在亮度控制按钮旁边有个小指示灯，标识着充电的状态。当电筒充满电时，拔出插头，把电源线再缠绕起来，放进底部，并盖上盖子。
5.请避免直视电筒，因为光源非常强。
6.充电时请保持电筒在关闭状态，否则会损坏LED。