1.1性能特点
◆产品适用于各种家用电器及家庭照明控制, 可以远距离遥控负载,在有效范围内，可以随意 操作控制各支负载，人体与市电完全分离，既安全又方便，给儿童和老年人带来诸多便利。
◆用电设备不工作时，完全切断电源，使用电设备时，待机零功耗；增加了设备的使用寿命；避免打雷、电源异常等因素引起的家用电器的损坏。
◆每个开关有各自独立密码，互不干扰，性能稳定，开关与遥控器之间采用智能学习对码，方便增配遥控器或增装开关。
◆一只遥控器可以控制多只遥控开关或一只遥控开关受多只遥控器控制。
◆在操作上具有遥控操作和手动操作两种功能，遥控与手动功能兼容，即无论是遥控或手动方式打开或关闭电源，用另一种方式都能把开关关闭或打开，做到既传统又现代。
◆具有来电自息功能，停电后再来电开关处于关闭状态，避免浪费。
Pls read the instruction manual carefully before use.
Features:
This product is widely used for varieties of home electric appliances and home lighting control, you can operate separate loads randomly in effective distance. Take more convenience for children and the elderly.
No need to fix direction for remote control, it is not be blocked off by barrier such as wall, glass, future, etc. can be operated randomly.
The power is cut off completely when the used device is not working, thus prolong the service life and avoid thunder, lightning, etc factors may cause the damage for the used device.
There is a separate code between each socket and remote control, make sure no any interference and performance stable.
Using “self-learning code” type between remote control and socket receiver, easy for you to match more socket receivers or one more remote control according to future demand.
Two operation ways are available: remote control and manual, these two ways can be compatible, say: whatever you open (or close) the power by remote control (or manual), it can be closed (or opened) by manual (or remote control), both traditional and modern.
The socket receiver will still remain in the “Off’ mode after a power out, even when the power comes on again.
With Master ON and OFF function for remote control, be very convenient for you to turn on or turn off all the socket receivers at one time.
二、技术指标
1.2.1 遥控器性能及指标
直流供电:
12V (23A12V电池一节)
发射频率:
433.92MHz
遥控距离:
≥30M (无障碍物)
1.2.2 插座性能及指标
电压范围:
AC 180V-250V / 50 Hz
最大负载电流: 10A (阻性负载）
Technical data
Socket receiver:
Working Voltage: 180-250V~/50Hz
Max load current: 10A
Remote control:
Transmitter: one ( 1 pc) 12V 23A battery
Transmission frequency: 433.92MHz
Remote control distance: ≥30M (free area)
三. 学习设置与清除记录
1.学习设置：
◆按住插座上的开关键，直到指示灯闪烁 （约5秒钟左右），松开按键，再按遥控器上的任意一键，指示灯停止闪烁，此时遥控器的该组按键已和此插座建立对应关系，学习成功。若5秒钟没有按遥控器，指示灯停止闪烁，自动退出学习模式。本插座最多能学习4组按钮，学习多于4组时将最开始学习的覆盖。
2.清除遥控器记录：
◆ 方法一：将插座从电源上拔下，按住插座上的开关按钮，再将插座上电，直到指示灯亮，松开按钮，清除该插座上的所有遥控器记录。
◆ 方法二：用一只遥控器的任意一键连续学习四次，可清除其它遥控器的记忆码，只有此遥控器可以遥控操作。
Detailed Learning Operation:
Learning Operation if need：
●Press the ON/OFF( Learning ) button of socket receiver for about 5 seconds till the Led indicator starts flashing.
Then release your hand, push the preferred ‘on’ or “off” number button of the transmitter, the Led indicator will not be in flashing state, It shows the learning operation is successful if the socket receiver can be controlled by the numbered button of transmitter. Following do other socket receivers’ learning operation one by one in the same way.
●Pls note:
1. The transmitter with 12V 23A battery is ready for learning operation in advance. Keep one hand press the ON/OFF ( Learning ) button on socket, the other hand holds the transmitter.
2. Each socket receiver can match 4 remote controls at most
3.
Clear the learning record of remote control and matched socket:
Method 1: pull the matched socket out from power supply, press the ON/OFF (Learning) button and plug the socket into power supply till the LED indicator starts flashing, release your hand, then it will clear the learning record of all remote controls for the matched socket.
Method 2: Use any one button of one remote control to do the learning operation for the matched socket 4 times continuously, then it will clear the records of all other matched remote controls, while only the remote control can operate.
四、注意事项
◆.请在使用前，详细阅读说明书。
◆.负载功率不能大于产品的额定功率。
◆.当发现遥控距离明显缩短、遥控迟钝，或遥控器指示灯明显变暗，请及时更换相同电池，废旧电池要按废物类别放置，注意环保。
Change the battery:
Regularly change the battery in the remote control for best use – however if you find the receivers are not responding or the LED indicator of remote control becomes dim, then you must change the battery at the earliest available time. Always dispose of old batteries with consideration for the environment.
NOTES:
●For indoor use only, far from high-temperature source, strong sunlight, raining and moisture places
●No need to do self- learning operation for first buy product.
● The remote control distance will becomes short obviously if the sockets are used near wall with sheet iron, especially near irregular corrugation armor plate places, such as garage, etc.
七.承诺
立煜承诺从购买之日起一年的质保期限，质保范围包括所有能被证明是由于原材料或制造面引起的严重损坏。只要符合以下条件，本公司将负责调换或免费维修有质量问题的智能无线遥控插座：
◆ 这些插座使用正确,而且是按照使用说明书的要求去做的。
◆ 用户或未经授权的第三方均没有擅自维修过。
◆ 因正常磨损而损坏的易损坏不属于质量范围。
◆ 制造商的这个保质条件不影响用户与销售商之间的质量条款。
◆ 如果您的无线遥控器与无线遥控插座发生了质量问题，请将购货凭证和保修卡，有关故障描述与无线遥控器以及无线遥控插座一起寄到本操作说明书后面的地址或者任一经销/代理或服务中心。
◆ 我们将您的无线遥控器与无线遥控插座修好后会给您邮寄回去。
Quality Warranty:
We will supply, at no charge, new or rebuilt replacements if products are determined to be defective in parts, function, performance or material etc for a period of 15 months after B/L date. However, this guarantee does not cover any damage due to improper operation, accident, misuse, abuse, negligence, commercial use, etc.
