HY-G1 电动球阀 产品特性

电动球阀适用于暖通空调水系统的通断控制，。

1.由于采用同步电机驱动、到位自动断电，功率消耗低，动作灵活，阀门柔性开启，能有效防止水锤
2.阀体内部采用独特的弹性双层密封结构，因而泄露少，并且阀门运行到位后电机不承受任何压力，电机寿命更长
3.阀轴与阀体之间采用特殊氟隆的填料及双“O”形环，可完全密封
4.驱动器和阀体之间采用罗纹连接，可在设备、管道安装完后再装，方便安装，更利于提高安装工效；拆掉驱动器球阀可用普通工具开关
5.驱动器采用密封结构，电器部分不受环境潮气影响

技术参数

控制特性：三线二控；三线一控,电机驱动复位
工作电压：230V AC   10%,50/60Hz
功率消耗：4W（仅当阀门开启、关闭时）
电机类别：双向同步电机
动用时间：15s（开～关）
引线长度：70cm
公称压力：1.6 Mpa
连接方式：管螺纹G
适用介质：冷冻水或热水
介质温度：2～90℃
环境温度：-5～60℃
泄漏量：≤0.008％Kvs（压差小于500Kpa时）
阀体：不锈钢/黄铜锻造
密封圈：聚四氟乙烯
O型圈：丁腈橡胶

HY-G1 electric valve Product Features

1. As a result of synchronous motor drive, place automated power, low power consumption, flexible movement, the flexible valve open, and can effectively prevent water hammer
2. Body flexibility within the unique double seal structure, and thus less leakage, and the valve motor is not running in place to withstand any pressure, longer motor life
3. Valve shaft and the body using a special Teflon between the filler and double "O" ring can be completely sealed
4. Drive and body connection between the use of rib, in equipment, piping installation and then install, easy to install, but also help improve the installation efficiency; removed the drive switch valve common tools available
5. Drive sealed structure, electrical parts from moisture of the environment

Technical parameters

Control features: three-wire two control; three lines of a controlled, motor-driven reset
Operating voltage: 230V AC 10%, 50/60Hz
Power consumption: 4W (only when the valve is opened, closed)
Motor Type: Two-way synchronous motor
Use of time: 15s (On ~ Off)
Lead length: 70cm
Nominal pressure: 1.6 Mpa
Connection: pipe thread G
Medium: chilled water or hot water
Medium temperature: 2 ~ 90 ℃
Ambient temperature: -5 ~ 60 ℃
Leakage: ≤ 0.008% Kvs (when the pressure is less than 500Kpa)
Body: stainless steel / brass forging
Seal: PTFE
O-ring: NBR