applied to either a hot or a cold mold (ambient to370°F /188°C). For best results, thePM-50Ashould be cured on the mold at200°F /93°Cor the molding temperature (whichever is higher) to achieve the maximum number of releases per application.

1.  Thoroughly clean the mold with Chem-Trend mold cleaner to remove the previous release agent or other contamination. Wipe dry with a clean cloth or towel. Then wipe with a clean solvent or naphtha and let air dry.

2.  Hold spray tip 4-10"/10-25 cmfrom surface and use a light, even spray.

3.  To pretreat or condition the clean mold, applyPM-50Ain a well-ventilated area. Apply at least three, uniform, thin coats and allow 5-10 minutes between applications for air drying of each coat. A short baking of the conditioned mold (10-15 minutes) at200°F /93°Cor the molding temperature (whichever is higher) will improve the durability of thePM-50Afilm and will provide the maximum number of releases per application. Begin molding.

4. Reapply a light coat of thePM-50Awhen required, to maintain desired release. To prevent buildup, avoid over-application.

Storage

Do not store at temperatures above100°F /38°C. Keep container tightly sealed to prevent evaporation and/or moisture contamination. If stored in cold temperatures, allow produPM to warm to room temperature prior to use.

We believePM-50Ahas a low degree of hazard when used as intended. For more information, request a copy of Chem-Trend\'s Material Safety Data Sheet.