'
北京益都旋翼式冷、热水表
|
一、北京益都旋翼式冷热水表结构与用途 Structure and Use | |
| (1)本水表是用于计量流经管道自来水或中水的体积总体量的流量测量仪表,适用于单向水流的自来水、井水、纯净水、中水等计量,该水表具有流通能力大,压力损益小,读数清晰直观,使用寿命长等特点。 (2)水压不大于1MPa (3)冷水水温不超过40℃且不低于0℃ (4)热水水温不超过90℃ | (1)This meter use to measure the mass of volume of tap water through pipe, suit to measure flux tap water, well water, pure water, and intermediate water in single direction. This meter has huge circulation, small pressure lost, clear number show and long work life feature. (2)The water pressure should under 1MPa (3) The cold water should under 40℃ and no less than 0℃ (4) The heat water meter should under 90℃ |
| | 二、北京益都旋翼式冷热水表15-40主要技术指标 Main parameter | |
| | 本表型号 lever model | 公称直径 mm rated diameter | 计量等级 account grade | 始动流量 m3/h begining flux | 最小流量 m3/h mimimum flowrate | 分界流量 m3/h transitional flowrate | 常用流量 m3/h permanent flowrate | 最大流量 m3/h overload flowrate | 最小示值 m3 Min show number | 最大示值 m3 Max show number | LXS-15C | 15 | 2级 | 0.010 | 0.031 | 0.050 | 2.500 | 3.125 | 0.0001 | 9999 | LXS-15E | 15 | 2级 | 0.010 | 0.031 | 0.050 | | | | | LXS-20C | 20 | 2级 | 0.010 | 0.050 | 0.080 | 4.000 | 5.000 | 0.0001 | 9999 | LXS-20E | 20 | 2级 | 0.010 | 0.050 | 0.080 | | | | | LXS-25C | 25 | 2级 | 0.010 | 0.078 | 0.126 | 6.3 | 7.875 | 0.0001 | 9999 | LXS-25E | 25 | 2级 | 0.010 | 0.078 | 0.126 | | | | | LXS-32C | 32 | 2级 | 0.030 | 0.125 | 0.200 | 10 | 12.5 | 0.0001 | 9999 | LXS-32E | 32 | 2级 | 0.030 | 0.125 | 0.200 | | | | | LXS-40C | 40 | 2级 | 0.030 | 0.200 | 0.320 | 16 | 20 | 0.001 | 99999 | LXS-40E | 40 | 2级 | 0.030 | 0.200 | 0.320 | | | | |
| (一)被测水温不能超过40℃ | (二)最大允许工作压力(公称压力)为10Kgf/cm2(98×104Pa) | | (三)在最大流量时,水表的压力损失不超过为1Kgf/cm2(98×104Pa) | | (四)从最小流量量至不包括分界流量的低区的示值误差限:±5% 从包括分界流量至包括最大流量的高区的示值误差限:±2% | | (一)The temperature of the water can\'t pass 40℃ |
|
(二)The rated pressure:10Kgf/cm2(98×104Pa) |
(三)The pressure lost in the water meter in Max flux ≤1Kgf/cm2(98×104Pa) |
(四)The show number error range form mix flux to the low district:±5% The show number error range form piding line flux to the high district:±2% |
注:(1)公称流量是水表在规定误差限内允许长期工作的流量。 (2)始动流量是水表开始连续指示时的流量,此时水表不计示值误差。 (3)最小流量是水表在规定误差内使用的下限流量。低于最小流量时水表不能准确计量。 (4)最大流量是水表在规定误差限内使用的上限流量。在最大流量时,水表只能短时间工使用不至损坏。 | Note:(1)Rated flux is the permitted flux in the long work situation for the water meter. (2)Beginning flux is the flux at the moment the meter open, and this time, the meter can\'t accout the show error. (3)The Mix flux is the permitted Mix flux for the meter, if the flux is lower than this number, the meter will not to account correctly. (4)The Max flux is the highest flux for the meter in the rated error, at the max flux the meter only work in a short time and not to broken. |
|
北京益都仪表成套厂主营:热量表及预付费IC卡控制阀冷、
热水水表和压力表、超声波冷热量表、温度计、蒸汽流量计、
电磁流量计、涡街流量计、等流量计产品。
联系电话:400-666-6613 010-67805059
网站地址:http://www.ydyb.com
北京益都仪表成套厂为您提供优质的售后服务!
'