DHO512-3600-005BEI编码器
DHO512-3600-005BEI编码器
DHO512-3600-005BEI编码器
本公司经营方向为,专业销售法国BEI-IDEACOD,德国hengstler,堡盟baumer,法国雷恩,德国梅尔品牌下各类中高端编码器 以及配件产品。
联 系 人:黄工
手 机:18201839208
电 话:021-61531185
腾讯Q Q :303321210
邮 箱:303321210@qq.com
本信息标题型号可能与本图片不一致,敬请谅解!
更多型号,不便列举,实在抱歉!
DEVICE NET ABSOLUTE MULTI-TURN ENCODER, MHK515-DNET RANGE ELECTRICAL DATA Interface Transceiver according ISO/DIS 11898 Power consumption max 2,5W Transmission rate Max 500KBauds Step frequency LSB 800 kHz Device addressing By rotary switches Accuracy of pision + ½ LSB Power Supply 10 – 30Vdc EMC EN 61000-6-4 EN 61000-6-2 Current consumption max. 100mA (24Vdc) Electrical lifetime > 105 h TRANSMISSION MODE Polled Mode By a telegram the connected host calls for the current process value. The absolute rotary encoder reads the current position value, calculates eventually set-parameters and sends back the obtained process value by the same identifier Change of State The absolute rotary encoder transmits the actual process value. The process value is transmitted when the position changes. This is useful to reduce the bus activity CYCLIC Mode The absolute rotary encoder transmits the actual process value event controlled by an internal timer. This is also useful to reduce the bus activity PROGRAMMABLES PARAMETRES Operating Parameters As operating parameters the code sequence (complement) can be programmed. This parameter determines the counting direction, in which the output code increases or decreases Resolution (pos./turn) The parameter resolution per revolution is used to program the desired number of steps per revolution. Value between 1 and 8 192 can be programmed Total Resolution “Max-RANGE“ This parameter is used to program the desired number of measuring units over the total measuring range. This value may not exceed the total resolution of the absolute rotary encoder. If the encoder is used in a continuous measuring application, certain rules for the setting of this parameter must be followed. These rules are outlined in the manual Preset Value The preset value is the desired position value, which should be reached at a certain physical position of the axis. The position value is set to the desired process value by the parameter pre-set INSTALLATION The rotary encoder is connected by three cables. The power supply is achieved with a two-wire connection cable through one PG 9. Each one of the twisted-pair and shielded bus lines are guided in and out through two PG 9 on the right side (as seen on clamps) CONFIGURATION The setting of the node number is achieved by 2 turn-switches in the connection cap. Possible addresses lie between 0 and 63 whereby every address can only be used once. 2 LEDs on the backside of the connection cap show the operating status of the encoder There is a resistor provided in the connection cap, which must be used as a line termination on the last device ORDERING REFERNCE (Contact the factory for special versions, ex: electronics, special flanges, connections…) MHK5 D2 B1 B 12 13 B 15 0 0CC Absolute multi turn encoder DEVICE NET Version Code : Binary Number of turns 212 (4 096) Resolution (steps/turn) : 213 (8 192) Blind Shaft Shaft diameter (reduction ring available upon request) Without mechanical options Connection Cap output Ordering code: MHK515-DNET-001= MHK5 - D2 B1 B – 12 13 - B15 0 - 0CC |