端口 控制简单，很容易安装机器，配合板卡信号，同时加有异常保护开关，检测外部是否通水、通风等。
激光功率调节既可以输入0到5V的模拟信号，也可以输入PWM信号用以控制激光功率的大小。
电源具有开路保护功能：在保护接地良好的情况下，电源可以短时间工作于开路状态，这样可以避免因激光管爆裂造成激光电源的损坏。
同时输出24V,和5V,方便机器的安装与调试。
出厂老化试验:
每台电源都会经过满载状态下高温60度12小时老化试验,7秒钟开停电源试验500次
主要技术参数：
交流输入电压 | AC220V 或 AC110V | |
直流输入电压 | DC300V 或 DC150V | |
交流输入频率 | 47～440Hz | |
最大电压输出 | 30KV | |
电压输出1 | 24V 1A | |
电压输出2 | 5V 1A | |
最大电流 | 20mA(视不同厂家的激光管) | |
效率 | 91% | |
过流保护 | 最大电流的130% | |
开路保护 | 有（短时间） | |
结构 | 风机冷却 | |
高电平控制电压 | ≥3V | |
低电平控制电压 | ≤0.6V | |
工作温度 | -30℃～+60℃ | |
相对湿度 | 20～85%RH（不结露） | |
耐压 | 输入—输出 | AC1500V1分钟≤10mA |
输入—壳 | AC1500V1分钟≤10mA | |
输出—壳 | 连接 | |
绝缘电阻 | ≥50MΩ（DC500V） | |
对地泄漏电流 | ≤1mA（AC220V）≤0.5 mA（AC110V） | |
抗振性 | 振幅0.5mm频率10～55Hz3维方向2小时 | |
无故障时间MTBF | ≥30,000hours | |
出厂满载60℃高温试验时间 | 12 hours | |
出厂7秒开停电源试验 | 500次 | |
最大尺寸（长*宽*高） | 165mm*145mm*90mm | |
Power Supply for Laser Engraving Machines
The power supply adopts zero-current half-bridge soft switching circuit, featuring high efficiency, fast response and easy matching for laser tubes produced by various manufacturers. Its ports can be controlled simply, easy to be equipped with machines and match the board signals. Meanwhile, it has an additional abnormal prevention switch for testing external water supply, ventilation, etc.
The laser power can be adjusted by entering either 0 to 5V analog signals or PWM signals.
The power supply has open circuit protection function: under the well-grounding circumstances, it can work under open circuit state within short term to avoid laser power supply damages caused by laser tube burst.
Meanwhile, it can output 24V and 25V, convenient for facility installation and commissioning
Ex-factory Aging Test:
Each power supply should go through 12-hour, 60℃ high temperature aging test under full load with 500 times power supply switches in 7 seconds.
Main Technical Parameters:
AC Input Voltage | AC220V or AC110V | |
DC Input Voltage | DC300V or DC150V | |
AC Input Frequency | 47~440Hz | |
Maximum Voltage Output | 30KV | |
Voltage Output 1 | 24V 1A | |
Voltage Output 2 | 5V 1A | |
Maximum Current | 20mA (depending on the laser tubes of different manufacturers) | |
Efficiency | 91% | |
Overcurrent Protection | 130% of maximum current | |
Open Circuit Protection | Yes (short term) | |
Structure | Fan cooling | |
High Electric Level Control Voltage Range | ≥3V | |
Low Electric Level Control Voltage Range | ≤0.6V | |
Working Temperature | -30℃~+60℃ | |
Relative Humidity | 20~85%RH (no condensation) | |
Voltage Resistance | Input—Output | AC1500V1minutes≤10mA |
Input—Shell | AC1500V1 minutes≤10mA | |
Output—Shell | Connection | |
Insulation Resistance | ≥50MΩ(DC500V) | |
Earth Leakage Current | ≤1mA(AC220V)≤0.5 mA(AC110V) | |
Vibration Resistance | Amplitude: 0.5mm frequency 10~55Hz 3D direction 2 hours | |
MTBF | ≥30,000 hours | |
Test Time at Full Load and 60℃ | 12 hours | |
Power Supply Switches Test within 7 Seconds | 500 times | |
Maximum Dimensions (L*W*H) | 165mm*145mm*90mm | |
