 | | 
300.00x101.00x82.00 (mm)
118.11x39.76x32.28 (inch) | |
| 
VOLTAGE: DC -36 V~ -72 V
INPUT CURRENT: 35A TYPICAL
INRUSH CURRENT: LESS THAN 10A FOR EACH MODULE | |
|
|
|
 | | Output Voltage | Output Current Min. | Output Current Max. | Output Current Peak | Regulation Load | Regulation Line | Output Ripple &
Noise Max.[P-P] | | 5V | 3.0 | 35.00 | | ± 5% | ± 50mV | 50mV |
|
| |
| -5V | 0.1 | 0.5 | | ± 10% | ± 120mV | 150mV |
|
| |
| -12V | 0.1 | 0.8 | | ± 10% | ± 120mV | 150mV |
|
| |
| |
| |
| |
| |
| |
| | REMARKS: 1.THE OUTPUT POWER OF 5V & 3.3V MAX: 35A
2.+5V, +3.3V AND +12V TOTAL OUTPUT MAX: 328W | 
* TEMPERATURE
RANGE: OPERATING: -10℃ --- 40℃(-36V ~-72VDC INPUT)
-10℃ --- 50℃(-46V~-72VDC
INPUT) STORAGE: -20℃ --- 80℃ * HUMIDITY:OPERATING:20%-95%,
NON-OPERATING:10%-95%
* REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH
SPECIAL COATING PROCESS
* HOLD UP TIME: 1.6 ms MINIMUM AT FULL LOAD &
NORMAL INPUT VOLTAGE
* DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1
SECOND INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
* EFFICIENCY: 65% TYPICAL
AT -48VDC FULL LOAD
* POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY
1 ms
* OVER POWER PROTECTION: 110% ~ 160%
OVER VOLTAGE PROTECTION: +5V →
5.7V ~ 6.7V, 3.3V → 3.7V ~ 4.7V +12V → 13.0V ~ 15.0V OVER CURRENT PROTECTION:
110% ~ 150%
* SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V,
+5VSB
* EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
* SAFETY: UL 1950,
CSA 22.2 NO/ 950, TÜV IEC 950
* REMOTE ON / OFF CONTROL
THE UNIT SHALL
ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE ALL THE OUTPUT
VOLTAGE (EXCLUDE +5V STANDBY), AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE
ENABLE, AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
* 3.3V / 5V
REMOTE SENSING
* CONNECTOR POWER INPUT
A. POSITRONIC: PLB06M CONNECTOR
B. TERMINAL BLOCK
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND
IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO
COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS. |
|
|
|
|
