打印机轴复印机轴 滚动轴等滚多花自动送料机
1.本机适用一轴滚多个直纹花 网纹花自动送料,能配各型号3T滚花牙机.
2.采用三菱PLC控制系统.搭配液晶屏幕显示操作.
3.以伺服马达及高精度滚珠丝杆作为送料作驱动.
4.解决了以前传统的滚一花需要人工定一次位,轴越长,定位长度越难保证.
5.加工精度效率高的特点,能自动定位,正负误差可达到0.05MM以下.
6.加工参数可自由设定.加工滚花数可达10个.
机型（Model） | GH0412 |
棒材直径(bar diameter) | ￠04MM-￠12MM |
棒材长度（bar length） | 200MM-450MM |
放料容量（Discharge capacity） | ￠6X200支 |
供气要求（Supply requirements） | 5KG/CM² |
供电要求（Power Requirements） | AC220V 50HZ |
Printer, copier axis roll shaft axis to spend more automatic roll feeder
1. This machine is used more than one axis roll textured flower flower ruled automatic feeding, the models can be equipped with knurled teeth 3T machine.
2. Mitsubishi PLC control system. With a liquid crystal display operations.
3. To the servo motor and high precision ball screw as feed for the driver.
4. To solve the traditional roll of a flower before the need to manually set a bit, the longer axis, positioning the length of the more difficult to ensure.
5. The characteristics of high efficiency, precision, can automatically locate, plus or minus up to 0.05MM below.
6. Processing parameters can be set freely. Processing roller spend up to 10.
