【代洋电器 ZY-SB114全不锈钢碎冰机冰粒机刨冰机制冰机】价格_厂家

品牌

代洋

型号

ZY-SB114

加工定制

是

电源电压

220V

'

本店产品统一不讲价直接拍

刨冰机88

碎冰机 (2)

碎冰机 (2)

刨冰机88

产品规格： 410*250*430

功率: 300W;
额定电压:220V/50Hz;
电机转速: 1400R/Min;
净重:7.5KG
毛重:8KG

茶餐厅、蛋糕房、面包房、咖啡店、饮品店、西餐店备、中餐店、调料加工厂、休闲食品厂

1、打开碎冰机盖，用干布擦净刨冰漕，检查刀片安装是否牢固。

2、检查电源电压是否于名牌所示电压相符，电源线及插头有无破损、漏电现

象，接触是否良好，关闭开关，插上电源。电源应接上可靠地线。

3、抬起压冰手柄，到上止点，插上电源，打开主开关，把盛冰盆放在底架上，

将碎冰机盖打开，将适量的冰块放入碎冰筒内。（注意：装冰量不能超出碎冰

筒平面）然后压下压冰手柄。使保证开关自动打开，达到碎冰效果。根据需要

调整刀刃调解柄即可加工各种粗细不同的刨冰。

4、工作完毕后，请抬起压冰手柄到上止点，在重复以上操作程序。

使用时，冰粒的出口不能堵塞，否则会造成卡刀盘，烧坏马达，如出现以上现象请立即抬起手柄，切断电源查明原因。

The product description：

Product specification:410 * 250 * 430
Power:200 w;
rated voltage:220 v / 50 hz;
The motor speed:1400 r/Min;
Net weight:7.5 KG
Gross weight:8 kg

Product scope：

Tea restaurant, a bakery, cake, coffee shop,beverage

stores, western food and Chinese food shop, condiment processing plants, leisure food factory

operation instructions：

1, open the ice crusher and then use dry cloth to wipe the shaved ice tank, check whether the blade installation is firm or not.

2, check whether the power supply voltage in the brand conform to shown in voltage or not,check the power cord and plug，current, contact are in good condition or not.
close the switch, plug in the power supply.the power supply can link with reliable ground wire.

3, put up the handle and to the top, plugged in and open the main switch then put thebasin of pack icein thechassis. in addition,Open the ice crusher cover and put ice into crushed ice buckets.(note: the ice cannot exceed the crushed ice tube surface) and then press down ice handle）To guarantee the switch automatically open to get the effect of crushed ice.difference ice can be made ording to the need adjust the blade to mediate the handle .
4, after the completion of the work, please raise the handle to the top and repeat the above procedures.

Cleaning and maintenance products：

When use ,the ice grains exit cannot be blocked, otherwise the cutter would be stuck and the motors would be burn out. If the above phenomenon appeared, please lift handle immediately , cut off the power supply and find out reason.