手动液压搬运车介绍
宽度
选择货叉的宽度取决于日常使用托盘的尺寸, 一般的手动液压车标准尺寸分宽车和窄车,宽车685*1200mm,窄车 540*1150mm。
width
Select the fork depending on the width of the daily use of the pallet size, size standard manual hydraulic car general points wide and narrow width of car car, car 685*1200mm, car 540*1150mm narrow.
载重
一般来讲,国际标准的有2.0t-2.5吨-3.0t-5.0t,这4种载重量。
load
Generally speaking, the international standard of 2.0t-2.5 tons of -3.0t-5.0t, the 4 kinds of load.
升降高度
国标的托盘高度一般在100mm,所以国标的手动液压搬运车最低高度当然在这之下。一般的液压搬运车放到最低点的时候高度是85mm、75mm两种,当然也有特殊的低放型手动液压搬运车,最低高度甚至能达到35mm。低放车一般价格稍贵,没有特殊需求不建议采购。而且低放到35mm的手动搬运车钢板相对来说比较薄,所以载重最多只有1.5吨。
![](http://img4.makepolo.cn/img4/139/901/100017413901_14589845068133.jpg)
![](http://img4.makepolo.cn/img4/139/901/100017413901_14589845129385.jpg)
![](http://img4.makepolo.cn/img4/139/901/100017413901_14589845175853.jpg)
Lifting height
The standard pallet height in general 100mm, so the minimum height of hydraulic manual handling car standard under which of course. General hydraulic handling vehicles to the lowest point when the height is 75mm, 85mm two, of course, there are special low discharge type manual hydraulic transport vehicles, the minimum height can even reach 35mm. Lower car prices are slightly more expensive, there is no special demand is not recommended to buy. But the manual handling car plate and low on 35mm are relatively thin, so load up to only 1.5 tons.
钢板厚度
一般好一点的3.0t的车采用的是4mm钢板,而差一些的钢板厚度加上油漆厚度都达不到4mm,有的甚至只能达到3mm,这样偷工减料换来的价格优势,对消费者是很不付责任的。这样的车容易在后续的使用中出现故障。另外,标准型的5.0t的手动液压车钢板厚度也要达到8mm以上,否则很难承受如此自重。
Steel plate thickness
General good of 3.0T car uses is 4mm steel plate, and some of the thickness of the steel plate and paint thickness of less than 4 mm, some even can reach 3mm, so Jerry in exchange for the price advantage, to consumers is is the responsibility of non payment. Such cars are prone to failure in the subsequent use of. In addition, the standard type of 5.0t manual hydraulic car steel plate thickness of 8mm or more, otherwise it is difficult to bear the weight.