SMP-600型高速涡轮式塑料磨粉机详情：
塑料磨粉机工作部分为刀盘，塑料破碎颗粒在高速的撞击齿轮板后被粉碎，然后由大功率吸风机将粉碎好的粉料吸出，较大的或未粉碎好的继续由刀盘进行粉碎，直到能够被吸风机吸出即可，这样的粉碎方式能够有效的减少刀盘的负荷，提高粉碎效率和质量，又能够使粉碎机粉碎好的粉料能够充分的冷却。
The plastic part is mill cutter, plastic particle crushing is shattered in the impact of high-speed gear plate, and then by the high-power suction powder suction fan will be crushed, larger or not crushed to crushed by the cutter, until the suction fan can be sucked out of this kind of way can be crushed the cutter can reduce the load, improve the efficiency and quality of grinding, and can make the mill powder grinding the sufficient cooling.
塑料磨粉机配置的是西门子牌的37kw大功率电机，能够起到很好地破碎效果和较大的撞击感，从而达到粉碎效果，而且塑料破碎机的内部电器元件都是用的施耐德或西门子的接触器或保护器，它的噪音小、安全、稳定、使用寿命长、不易出现故障等优点。
Machine configuration is 37KW high power motor brand SIEMENS, can play a good crushing effect and high impact sensitivity, so as to achieve the crushing effect, and plastic crushing machine internal electrical components are used in Schneider or SIEMENS contactor and protector of the advantages of its low noise, stability and safety long service life, less failure etc..
温度低是塑料破碎机的主要优点。按热功能量相当来计算：每小时工作后转换为860千卡热能，塑料破碎机有外吹风和冷水接入两种方式，外抽风的抽风量高达50m³/kw，由进出口的风温差来带走塑料磨粉机的大部分热能。少部分热能由水冷却来解决。对于水的温度要求为：进水温度不得大于25C°、出口温度不得高于45C°，夏天应适当增加磨粉机进水口的水流，从而达到降低温度。
Low temperature is the main advantage of plastic crusher. According to the heat energy is calculated per hour after conversion to 860 thousand calories, plastic crusher has external blowing and cold water access in two ways, the amount of ventilation ventilation outside up to 50m /kw fand most of the heat energy by wind, temperature difference between import and export to take plastic mill. A small part of the heat energy is cooled by water. The water temperature required for water temperature not greater than 25C degrees, the outlet temperature shall not be higher than 45C degrees, the summer should be appropriate to increase the mill inlet flow, so as to reduce the temperature.
