河北骏豪机械设备有限责任公司

联系人：张经理13933000298

1、启动时保持适当的启动速度，不应过猛。
2、注意观察电压表的电压，若低于限制电压时，叉车应立即停止运行。
3、叉车在行走过程中，不允许扳动方向开关而改变行驶方向，以防烧坏电器元件和损坏齿轮。
4、行驶与提升不宜同时进行。
5、注意驱动系统，转向系统的声音是否正常，发现异常声音要及时排除故障，严禁带病作业。
6、转变时要提前减速。
7、在较差道路情况下作业时，其重要适当减轻，并应降低行驶速度。
Operating rules
1, starting to maintain proper starting speed, should not be too fierce.
2. Pay attention to the voltage of the voltmeter. If the voltage is lower than the limit, the forklift should stop running immediately.
3, forklift in the process of walking, not allowed to pull the direction switch, and change the direction of travel, in order to burn out electrical components and damage gear.
4, driving and promotion should not be carried out simultaneously.
5, pay attention to drive the system, steering system sound is normal, abnormal sound should be found out in time, is strictly prohibited operation.
6, slow down in advance.
7, in the poor road conditions, the operation of the importance of appropriate mitigation, and should reduce the speed of travel.
光阴易逝，韶华不再。已经的岁月有多少青春神韵、飞扬豪情，又有多少馨梦柔肠、温婉密爱，还有多少恩恩怨怨、是是非非，当繁华褪去，才发觉，浮生尘世聚散匆匆、爱恨悠悠、财色空空，所有一切只不过是一壶浊酒、半屏青山，俯首之间，已是一去千里，永成过往。 昨还是春光明媚、红杏出墙，今已是秋风萧煞、黄花满地；昨还是志存高远、踌躇满志，今已是心淡神定、宠辱不惊；昨还是是非恩怨、爱恨情仇，今已是心如止水、笑看人生。
1、起重前必须了解货物的重量，货重不得超过叉车的额定起重量。
2、起重包装货物时应注意货物包扎是否牢固。
3、根据货物大小尺寸，调整货叉间距，使货物均匀分布在两叉之间，避免偏载。
4、货物插入货堆时门架应前倾，货物装入货叉后，门架应后倾，使货物紧靠叉壁，并尽可能将货物降低然后方可行驶。
5、升降货物时一般应在垂直位置进行。
6、在进行人工装卸时，必须使用手制动，使货叉稳定。
7、行走与提升不允许同时操作。
8、在大坡度路面运载货物时，注意货物在货叉上的牢固程度。
Matters needing attention
1, lifting must understand the weight of the goods, goods weight shall not exceed the lifting weight of forklifts.
2, lifting the packaging of goods should pay attention to the cargo bandage is firm.
3, according to the size of goods, adjust the fork spacing, so that the goods evenly distributed between the two forks, to avoid partial load.
4 when the goods are inserted into the cargo heap, the door frame shall lean forward and the goods are loaded into the cargo fork. The door frame shall be bent backward so as to make the goods close to the fork wall, and reduce the goods as much as possible, and then drive.
5, the lifting of goods in general should be carried out in a vertical position.
6, in manual handling, you must use hand brake, so that fork stability.
7, walking and lifting are not allowed to operate simultaneously

8, in the large slope of the road carrying goods, pay attention to the cargo on the fork firmly.