该产品属于混合交联剂，对白胶、EVA乳液、PVA胶水、丙烯酸乳液等均有良好的防水交联剂作用。该产品外观为固态颗粒。
This product belongs to the mixed crosslinking agent. It has a good waterproof crosslinking effect for PVAc, EVA emulsion, acrylic emulsion and so on. This product appeared as solid particles
使用范围：该产品对一些常用的PVA溶液，丙烯酸乳液、EVA乳液、白胶均能产生良好的交联作用，从而提高产品的耐水性能，广泛适用于多种类型的水性胶黏剂。
Scope of use: The product can produce a good crosslinking effect on PVA solution, acrylic emulsion, EVA emulsion and PVAc, thus improving the water resistant performance of products and is widely used in various types of water-based 防水交联剂EN-20 Waterproof crosslinking agent EN - 20
adhesive.
使用方法：使用前用冷水溶解，与水的配比一般1:1，常温加入即可，搅拌半个小时后放料。
Instructions: Dissolve it in cold water before using, and with a ratio of 1:1 in normal temperature. Stir for half an hour and then put the material.
使用量：根据产品的耐水要求来决定加入量，一般加入量为5-15kg/t,特殊要求可以加入5%的含量。
Usage: The adding amount depends on the waterproof requirements of the product. Generally, the adding amount is within 5 to 15 kg/t. If special requirements needed, you can add the content of 5%.
注意事项：1.由于该交联剂在常温下交联能力很强，过量的加入会影响产品的储存时间，但是5-15kg/t一般不会影响储存期。加入量2%以上，储存期会受到影响，但耐水性能可以大大提高。最高使用量不超过5%。
2.由于该防水剂是偏酸性物质，对身体有一定刺激，故在配制使用时注意防护，带好手套和眼镜。
3.该防水剂易吸潮，使用后马上盖好，以防吸潮，影响配比，但不会影响防水效果。
4.因各企业配方、要求等均不同，望使用后，再大批量使用，以免带来损失。
Note: 1. As the ability of the crosslinking agent at room temperature is very strong, excessive adding will have an influence on the storage of the products. Generally, the adding amount for 5-15 kg/t will not affect the storage life. If more than 2%, the storage is affected, but it can greatly improve the performance of water resistance. The highest amount shall not be exceeded over 5%.
2. Since the waterproof agent is partial acid, it has certain stimulation to the body, therefore, when using it, pay attention to the protection and please bring gloves and glasses.
3. The waterproof agent is easy to absorb moisture, so cover it immediately after using to avoid moisture absorption and affect the ratio. But it will not affect the waterproof effect.
4. The formulation and requirements for various enterprises are different, so it is suggested that firstly using small amount, if the effect is good, then start with mass usage to avoid damage.
