ontrol interface unit IDENTControl Compact with PROFIBUS DP interface

General specificationsIndicators/operating meansElectrical specificationsInterface 1Interface 2Directive conformityStandard conformityAmbient conditionsMechanical specifications

Number of read/write heads		max. 2 alternatively 1 read/write head and 1 trigger sensor
UL File Number		E87056
LEDs 1, 2		Status indicator for read/write heads green: command at read/write head active yellow: approx. 1 second long, if command was successfully executed
LEDs CH1, CH2		green: read head detected red: Configuration error
LED PWR/ERR		green: power on red: Hardware fault
Rotary switch		Address setting 00 ... 7E, FF (hexadecimal) BUS Address (high nibble): 0 ... 7, F BUS Address (low nibble): 0 ... F
Rated operating voltage		20 ... 30 V DC , PELV
Ripple		≤ 10 % at 30 V DC
Current consumption		≤ 4 A incl. read/write heads
Power consumption		2 W Without read/write heads
Galvanic isolation		basic insulation acc. to DIN EN 50178, rated insulation voltage of 50 Veff
Interface type		PROFIBUS
Physical		RS-485
Protocol		PROFIBUS DP acc. to EN 50170
Interface type		Diagnostic Interface
Physical		RS 232
Protocol		ASCII
Transfer rate		38.4 kBit/s
Electromagnetic compatibility
	Directive 2014/30/EU	EN 61000-6-2:2005, EN 61000-6-4:2007
Degree of protection		IEC 60529:2001
Ambient temperature		-25 ... 70 °C (-13 ... 158 °F)
Storage temperature		-40 ... 85 °C (-40 ... 185 °F)
Climatic conditions		air humidity max. 96 %  Salt spray resistant to EN 60068-2-52
Shock and impact resistance		Oscillation (Sine): 5 g, 10 - 1000 Hz to EN 60068-2-6 Shock (Half-sine): 30 g, 11 ms in accordance with EN 60068-2-27
Degree of protection		IP67
Connection		Read/write heads: shielded, 4-pin, M12 connector  Power supply: M12 connector  Protective earth: M4 earthing screw  Diagnostic RS 232: M12 connector  PROFIBUS: M12 connector, B-coded
Material
	Housing	Powder coated zinc
Installation		screw fixing
Mass		approx. 500 g