机械革新 与您携手创辉煌
马鞍山力长机械主要产品有：数控液压折弯机、数控液压摆式/闸式剪板机、矩型风管自动生产线、共板式(TDF)法兰成型机、插接式(TDC)法兰成型机、咬口机、折边机、调平压筋机、辘线机、卷板机、角铁卷圆机、剪圆机、剪角机、联合冲剪机、冲床、液压铆接机等等。本公司将竭尽所能为您提供最完善的售后服务！
马鞍山力长机械免费咨询热线：400-016-2122
温 馨 提 示
产品图片、属性及价格等仅供参考，详情请来电或旺旺咨询！
以下是图片展示，机床详细介绍（包括中文版、英文版文字介绍）
一 产品介绍
全钢焊接结构，具有足够的强度与刚性。液压上传动；
具有快速接近、加压、卸压快速退回功能；
滑块同步采用抗扭连杆和机械挡块机构；
折弯角度，后挡料距离采用电动调节，手动微调，数字显示；根据用户需要可加装数控装置。
Introduction of a product
All steel welded structure, with sufficient strength and rigidity. Hydraulic transmission;
With fast approaching, pressure, unloading fast return function;
The slide block is synchronized with anti torsion bar and mechanical block mechanism.;
From the angle of bending, the distance of the rear stopper is adjusted by electric adjustment, and the digital display is adjusted manually. The numerical control device is installed according to the user's need..
折弯机机维护保养的方法
1、严格按照操作规程进行操作。
2、每次开机前按润滑图表要求定时、定点、定量加润滑油，油应清洁无沉淀。
3、机床必须经常保持清洁，未油漆的部分应涂抹防锈油脂。
4、电动机轴承内的润滑漾油要定期更换加注，并经常检查电器部分工作是否正常安全可靠。
5、定期检查链条、手柄、旋钮、按键是否损坏，磨损严重的应及时更换，并报备件补充。
6、定期检查修理开关、保险、手柄、保证其工作可靠。
7、每天下班前10分钟，对机床加油润滑及擦洗清洁机床。
8、严禁非指定人员操作该设备，平常必须做到人离机停。
A method for maintenance of bending machine
1, strictly follow the operation procedures for operation.
2, every time before the start of the lubrication chart to require the timing, fixed point, quantitative lubricating oil, oil should be clean without precipitation.
3, machine tools must often keep clean, the part of the paint should be coated with rust preventive grease.
4, motor bearing lubrication overflow oil should be changed regularly filling, and always check whether the normal work of safe and reliable electrical parts.
5, regularly check the chain, handle, knob, key press whether damage, wear serious should be replaced, and to spare parts for spare.
6, check the repair switch, insurance, handle, guarantee its work reliably.
10, 7 minutes before work every day, lubrication and cleaning machine tool for machine tools.
8, non designated personnel to operate the device, usually must be done to stop the machine.
