手动皮带切割机特点

1.可双向切割输送带，切割端边平、直；
2.配备一把一米长度的可折叠式直角尺，用于切割时检验垂直度；
3.操作轻快，维修方便；
4.结构坚固，重量轻，便于携运；
手动皮带切割机的使用方法：
1.选择方向将销钉拔出，然后将夹板抬起。
2.皮带放在机体上．选择好切割位置，将夹板放下插入销钉
3.将夹紧手柄旋转压紧位置。
4.把扳手套在驱动轴上，旋转手柄即可。
此款皮带切割机适合不含钢丝的工业PVC PVG皮带切割使用
我们同时还有手用割刀及刀片配件销售。

Features of manual belt cutting machine 1. Bi-directional cutting conveyor belt, cutting edge flat, straight;
2. Equipped with a one-meter length of the foldable square for cutting perpendicular to the test;
 3. Easy to operate and maintain.
4. Strong structure, light weight, easy to carry; manual belt cutting machine usage:
 1. Pull the pin out in the selected direction and lift the splint.
 2. Put the belt on the body. Select the cutting position and lower the splint into the pin
 3. Rotate the clamping handle to tighten position.
4. Place the wrench on the drive shaft and rotate the handle. This belt cutting machine is suitable for industrial PVC

PVG belt cutting without steel wire. We also sell hand knives and blade accessories.

手动皮带切割机用途
用于输送带横向端边切割。使用GT系列输送带切割机切割输送带，可使操作轻便、快捷，并且切割端边平整，与带边垂直。有利于带扣装

订后扣带距离均匀，接头与带边垂直，减少输送带运行中的跑偏的因素。

Manual belt cutting machine is used for cutting the transverse end of conveyor belt. GT series conveyor belt cutting

machine cutting conveyor belt, can make the operation easy and fast, and cutting end flat, and vertical with the belt

edge. The utility model is advantageous to the uniform distance of the buckle after the buckle is bound, the joint is

perpendicular to the belt edge, and the factors of the running deviation of the conveyor belt are reduced.

手动皮带切割机规格：650mm、800mm、1000mm、1200mm、1400mm，1600mm、1800mm等，您的输送带多宽您就买多大的。
皮带切割机主要适用25公分以内的皮带，25公分以上32公分以下的皮带需要定制刀片
直角割皮机能够保证输送带的对接垂直，不会出现接完输送带跑偏的现象。 
Belt cutting machine is mainly suitable for belt within 25 cm, 25 cm above 32 cm below the belt needs custom blade right

angle cutting machine can guarantee the belt docking vertical, there will not be finished conveyor belt misalignment

phenomenon.