数字轴入口DI5，DI7 和DI8的使用方法
●数字口DI5;定为急停功能。
●运行时，DI5必须设置为“1”.如果设置为“0”,报警信号A102将会出现.传动将会根据参数917设置的功能作出反应(按照斜坡。转矩/电流限幅，调节器封锁和
自由停车方式关机.斜坡功能完成之后(谴度反馈低于nmin),通过控制主回路接触器，使输出复位。之后,急停输入应重新设置为“1”报警信息ON/OFF输入同样被设置为.“0”.之后传动能够重新起动。
●数字口DI7;定为起动1停止(ON0OFF)功能。
供连接传动与进线回路, DI7必须设置为逻辑“1”.如果没有故障,用于控制电枢.回路和磁场回路的接触器合闸的数字输出口被激活。如果DI7设置为“0”,内部的控制器停止工作,通过延时数字输出口复位.只有当连线是按接线图2设置时,通过参数915设置的功能才会有效。(输入DI7和DI8用于分断接触器)_
Use of digital shaft inlet DI5, DI7 and DI8. Digital Port DI5; set as emergency stop function. At run time, DI5 must be set to’1’. If set to”0”, alarm signal a 102 will appear. The drive will respond to the function set by parameter 917(follow the ramp. Torque/current limiter, regulator lockout and free stop mode shutdown. After the ramp function is completed (densitometric feedback is lower than Nmin) , the output is reset by controlling the main loop contactor. After that, the emergency stop input should be reset to “1”alarm information. The ON/OFF input is also set to. . Zero. The drive can then be restarted. Digital Mouth DI7; set to start 1 stop (ON0OFF) function. The DI 7 must be set to logic”1”for connecting drive and feed circuits. If there is no fault, use to control the armature. The digital output of the contactor closing of the loop and the magnetic field loop is activated. If di 7 is set to 0, the internal controller stops working and resets via the delayed digital output port. The function set by parameter 915 is only valid if the connection is set in accordance with wiring Diagram 2. Enter DI7 and DI8 for breaking contactor
