开关电源D-60系列
低电压、高可靠 Low price and high reliability
105℃输出电容器 105℃ output capacitor
全球适用AC输入电源 AC input power suitable for the world
效率高、工作温度低 High efficiency and low operation temperature
软启动电流、有效降低AC输入冲击 Soft-start current can reduce the AC input impact efficiency
有短路保护、过载保护 With short-circuit and overload protection
体积小、重量轻 Compact size, light weight
100﹪满负荷烧机测试 100﹪full-load burn-in test
内装EMI滤波器、纹波极小 Installed with EMI filter, minimum wave
|
型号 Mode
性能 Performance |
D-60A |
D-60B | ||
|
CH1 |
CH2 |
CH1 |
CH2 | |
|
直流输出电压 DC output voltage |
5V |
12V |
5V |
24V |
|
输出电压公差 Output voltage tolerance |
±2﹪ |
±6﹪, |
±2﹪ |
±8﹪ |
|
额定输出电流 Rated output current |
6A |
3A |
4A |
1.8A |
|
输出电流范围 Output current range |
1～6A |
0.2～3A |
1～24A |
0.2～1.8A |
|
纹波及噪音 Ripple and noise |
75mVp-p |
150mVp-p |
75mVp-p |
150mVp-p |
|
进线稳定度 Inlet stability |
±0.5﹪ |
±1﹪ |
±0.5﹪ |
±0.5﹪ |
|
负载稳定度 Load stability |
±0.5﹪ |
±4﹪ |
±0.5﹪ |
±4﹪ |
|
直流输出功率 DC output power |
66W |
63W | ||
|
效率 Efficiency |
73% |
73% | ||
|
直流电压可调范围 Adjustable range for DC voltage |
CH1; +10,-5% |
CH1; +10,-5% | ||
|
输入电压范围 AC input voltage range |
85～132VAC/170～264VAC由开关选择47～63Hz; 240～370VDC 85～132VAC/170～264VAC selected by switch 47～63Hz; 240～370VDC | |||
|
输入电流 Input current |
2 A/115V 1A/230V | |||
|
冲击电流 AC dash current |
冷启动电流 30A/115V 60A/230V Cold-start current 30A/115V 60A/230V | |||
|
漏电流 Leakage current |
＜1mA/240VAC | |||
|
过载保护 Overload protection |
105﹪～150﹪类型：电流限制 复位：自动恢复 105﹪～150﹪ Type: pulsing hiccup shutdown reset: auto recovery | |||
|
过电压保护 Over-voltage protection |
………………… | |||
|
高温保护 High-temperature protection |
…………………. | |||
|
温度系数 Temperature coefficient |
±0.03﹪/℃(0～50℃)ON+5V | |||
|
启动、上升、保持时间 Startup .rise .retention time |
800ms 50ms 30ms/115V 300ms,50ms,80ms/230VAC | |||
|
抗震性 Vibration |
10～500Hz, 2G 10min/1周期，时长60分钟，各轴 10～500Hz, 2G 10min/1 cycle , Period for 60 min , Each axes | |||
|
耐压性 With standard voltage |
输入输出间：1.5KvAC输入与外壳： 1.5KvAC输出外壳： 0.5KvAC Input and output internal ：1.5KvAC input and enclosure ： 1.5KvAC output and enclosure： 0.5KvAC | |||
|
隔离电阻 Isolation resistance |
输入输出间： 输入与外壳，输出与外壳：500VDC/100MΩ Input and output internal: input and enclosure. Output and enclosure: 500VDC/100MΩ | |||
|
工作温度、湿度 Working temperature and humidity |
-10℃～+60℃(参考输出特性图)，20﹪～90﹪RH -10℃～+60℃(Refer to output diagram cech，20﹪～90﹪RH | |||
|
存储温度、湿度 Store temperature and humidity |
-20℃～+85℃, 10%～95%RH | |||
|
外型尺寸 Overall dimension |
159×97×38mm | |||
|
重量 Weight |
0.55kgs | |||
|
安全标准 Safety standards |
UL1012 TUV按6050（IEC,UL1950）认证 UL 1012 TUV EN6050(IEC,UL1950) Approved | |||
|
EMC标准 EMC standards |
满足FCC部分15J条件等级B Meet FCC PART 15J condition class B | |||
|
备注： 1.以上参数测试条件为：230VAC输入，额定负载,25℃ 70%Rh,温度。 2．容差： 包括设定容差，线路稳定度，负载稳定度 3．纹波测试：20MHz用“A12”双绞线，中断用0.1uF&47uF电容器短路。 4．进线电压稳定度测试：满负载时进线最低电压到最高电压。 5．负载稳定度测试：负载从0%到100% 6.各输出可达最大电流，但总负载不可超过最大输出功率。 7．C2、3、6必需拆除。 Note : 1. The testing condition for the parameter above is : 230VAC input ,rated load, 25℃ 70%Rh. Temperature. 2. Error, include the setting error, line stability and load stability . 3. Wave test: adopt “A12” double wire for 20MHz, and 0.1UF & 47UF capacitor short-circuit for interrupting. 4. Inlet voltage stability test: when is over load, the lowest voltage of inlet is up to the highest voltage. 5. Load stability test: The load is from 0% to100% 6．Total output maximum current , total load can not exceed the maximum output power. 7. C2、3、6 must be knocked down. | ||||
