序号	控制电机容量	型号（隔离型）
1	0.05-0.12KW	YO-KBO-12C/M0.4/06MG
2	0.12-0.20KW	YO-KBO-12C/M0.63/06MG
3	0.20-0.33KW	YO-KBO-12C/M1/06MG
4	0.33-0.53KW	YO-KBO-12C/M1.6/06MG
5	0.53-1KW	YO-KBO-12C/M2.5/06MG
6	1-1.6KW	YO-KBO-12C/M4/06MG
7	1.6-2.5KW	YO-KBO-12C/M6.3/06MG
8	2.5-5.5KW	YO-KBO-12C/M12/06MG
9	5.5-7.5KW	YO-KBO-16C/M16/06MG
10	7.5-11KW	YO-KBO-32C/M25/06MG
11	11-15KW	YO-KBO-32C/M32/06MG
12	15-18.5KW	YO-KBO-45C/M40/06MG
13	18.5-22KW	YO-KBO-45C/M45/06MG
14	21-24KW	YO-KBO-63C/M50/06MG
15	25-29KW	YO-KBO-63C/M63/06MG
16	30-37KW	YO-KBO-100C/M80/06MG
17	37-45KW	YO-KBO-100C/M100/06MG
18	45-55KW	YO-KBO-125C/M125/06MG

一、YO-KBO控制保护开关产品概述 : www.shyokbo.com

CPS(KB0)-G隔离型

CPS（KB0)-G隔离型产品适用于配电电路和电动机电路中电源的隔离，既可满足主电路隔离的要求，也可满足控制回路隔离的要求。

主电路和附件模块的主要参数同基本型。

隔离型产品在手柄处于隔离位置时，具有锁扣装置，可以加锁，挂锁由客户自备

二、与塑壳断路器相比

a. 具有分断能力高、飞弧距离短的特性

    CPS(KB0)在380V额定运行短路分断能力Ics (o－co-co) 达到高分断型为80kA、标准型为50kA、经济型为35kA, 在50kA 预期短路电流下的分断时间仅为2～3ms, 限流系数达到0.2以下，达到塑壳断路器的领先水平，达到熔断器的限流水平，大大限制了短路电流对系统的动、热冲击。CPS(IKBO)飞弧距离仅为20～30mm。

b. 与塑壳断路器构成的保护系统相比，具有保护整定电流均可调整的特性

    CPS(KBO)的电流均可在面板上进行调整，即除了常规的保护电流可根据负载功率进行整定外，过流保护整定电流在调整电流数值时同时进行调整(配电负载的调整范围为3～6Ie，电动机负载的调整范围为6～14Ie)。克服了塑壳断路器的短路保护整定电流出厂后用户无法调整的缺点，使得CPS(KB0)产品即使安装在线路末端，短路电流较小时，同样具有很好的短路保护功能。

与接触器性能相比具有寿命长、操作方便的特性

      手动操作，又可实现远距离自动控制功能。采用了先进的触头与电磁系统分离式设计，有效抑制了触头的二次弹跳，大大提高了产品的电寿命，而且特别适用于重载起动等严酷的场合。

三、产品优势

 与分离电器构成的系统相比

a. 具有控制与保护自配合的特性

     CPS(KB0)系列控制与保护开关电器集控制与保护功能于一体,相当于断路器(熔断器)＋接触器＋过载继电器＋辅助电器。很好的解决了分离元件不能或很难解决的元件之间的保护与控制特性匹配问题，使保护与控制特性配合更完善合理( 具有反时限、定时限和瞬时三段保护特性)，只要根据负载功率或电流即可正确选择单一产品,代替以往的包括自电源进线端至负载端的各种电器，不需降容；大大减轻了设计人 员的工作量。

b. 具有无可比拟的运行可靠性和系统的连续运行性能

     CPS(KB0) 在分断短路电流后无需维护即可投入使用，即具有分断短路故障后的连续运行性能：CPS(IKB0) 在进行了分断短路电流试验后，仍具有不小于1500次的AC-44电寿命，这是由断路器等分离元件构成的系统所难以达到的，CPS(IKB0)的这一特性极大地提高了系统的运行可靠性和系统的连续运行性，其中的Ics为80kA指标属同类产品的国际领先、国内最高指标。

c. 节能节材

     CPS(KB0)具有体积小、安装面积少、无分离元件接点、减少线路发热、

CPS (KB0) isolate -G isolated products applicable to the power distribution circuit and electric circuit, the main circuit can meet the isolation requirements, but also to meet the requirements of control loop.
The main parameters of the main circuit and the accessory modules with basic type.
Isolation type products in the isolated position, with locking device can lock, padlock, by the customer
Compared to two, and the moulded case circuit breakerwww.yoybdq.com

A. has the characteristics of high breaking capacity, arcing distance is short
CPS (KB0) in 380V rated service short-circuit breaking capacity of Ics (o Co-Co) to achieve high breaking type 80kA, type 50kA, standard economic type is 35kA, 50kA is expected in the short circuit current under the breaking time is only 2 ~ 3MS, current limiting factor is less than 0.2, leading to the moulded case circuit breaker, to fuse the limiting level, greatly limiting the short-circuit current of system dynamic, thermal shock. CPS (IKBO) arcing distance is only 20 ~ 30mm. www.shrmhz.com 
Compared with the protection system of B. and moulded case circuit breaker which has protective properties, setting current can be adjusted
CPS (KBO) of the current can be adjusted in the panel, which in addition to the protection current conventional according to load power setting, over current protection setting current and adjusted in the adjusted current value (distribution load adjustment range is 3 ~ 6Ie, the motor load adjustment range is 6 ~ 14Ie). To overcome the short circuit breaker protection setting current factory after the user can not adjust the shortcomings, such that CPS (KB0) products even installed at the end of the line, is small short circuit current, also has the short circuit protection function is very good.  www.shrmyb.com
Compared with the contactor performance has the characteristics of long service life, convenient operation
Manual operation, and can realize remote control function. The contact and electromagnetic system advanced separation type design, effectively inhibit the two spring contacts, greatly improving the electrical life of the product, and is especially suitable for heavy load starting and other harsh occasions.
Three, product advantagewww.kawa10.com
Compared with the system structure and separation apparatus
A. has the characteristics of control and protection from the
CPS (KB0) series of control and protective switching control and protection functions in one, the equivalent circuit breaker (fuse) + + + auxiliary electrical overload relay contactor. The matching problem between protection and control characteristics of a good solution to the separation element cannot or difficult to solve element, the protection and control characteristics with more perfect and reasonable (with anti time limit, time limit and instantaneous three section protection characteristics), as long as the load to the power or current correct selection of a single product, instead of including all electric self power into the line end to end, without derating; greatly reduces the workload of design personnel.www.shyosdy.com              
Continuous operation performance of B. with reliability and system There www.shyohz.com