KR-A1Epoxy Zinc-Rich Primer
概述:该漆为双组份重防腐底漆,广泛用于集装箱、船舶、港口设施、海上采油设备、化工设备、钢结构等的长效防腐。
Description: The two-component heavy-duty primer paint is widely used in containers, ships, port facilities, offshore oil equipment, chemical equipment, steel and other long-term corrosion.
特性:锌粉含量高,有阴极保护作用;防锈性能优异;附着力强.
Feature: A high zinc content and provides cathodic protection; excellent anti-rust properties and strong adhesion.
主要技术指标Technical indicators:
项目 Item | 指标 Indicators | |
漆膜颜色与外观 color and appearance | 灰色,漆膜平整光滑 Gray, smooth film | |
供货粘度 Availability viscosity | 具有触变性 Thixotropic | |
使用粘度 Viscosity of usage | (30-50)sec/20℃(涂-4杯)(加入固化剂) (30-50)sec/20℃(Tu -4 cups) (with curing agent) | |
密度(g/cm3) Density(g/cm3) | 2.70±0.20
| |
光泽度 Gloss | 半光或无光 Half light or no-light | |
固体体积含量(ml/kg) Volume solids | 200±3%(加入固化剂后) 200±3%(with curing agent) | |
理论涂布率(g/m2) Theoretical spreading rate | 150 | |
干膜厚度(μm) Thickness | 30 | |
干燥条件,自然干燥 Drying conditions, natural drying | >10℃ | |
烘干 Drying | <150℃ | |
相对湿度 Relative humidity | ≤85% | |
干燥时间(20℃)h Drying time | 表干 Set to touch | ≤2 |
实干 Completely dry | ≤24 | |
完全固化 Fully cured | 7d或(1-2)h/(70-90)℃ | |
重涂间隔 Recoating interval | 6h | |
施工参考Construction Reference:
1、表面处理:表面须经喷砂处理,粗糙度达到SIS Sa2.5级。
Surface preparation: Abrasive blasting to SISSa2.5 with the surface.
2、施工说明Construction Description:
施工方法 Construction Method | 粘度 Viscosity | 配套稀释剂 Thinner |
空气喷涂 Air Spray | (20-30)sec | H-1 |
无气喷涂 Airless spray | (30-50)sec | H-1 |
滚涂/刷涂 Roller / brush | 根据需要 Required | H-1 |
3、涂料配套coatings matching:
(1)表面经喷砂处理
Surface by sandblasting
(2)底漆:KR-A2
Primer: KR-A2
(3)面漆:KR-A3 KR-A6等
Topcoat: KR-A3 KR-A6 sec.
安全 SAFETY
请注意包装标签上的安全事项。此外, 还应遵守有关国家或当地政府规定的安全法规。避免吸入溶剂蒸汽或漆雾, 皮肤、眼睛不得接触本品。在狭窄处或空气不流通处施工, 必须提供强力通风。尽管通风条件良好也应配戴防护用具。
Packings are provided with applicable safety labels which should be observed. In addition, national or local regulations should be followed. As a general rule, inhalation of solvent vapours or paint mist, and contact of liquid paint with skin and eyes, should be avoided. Forced ventilation should be provided when applying paint in confined spaces or stagnant air. Even when ventilation is provided, respiratory, skin and eye protection are always recommended when spraying paint.
特别注意:Special Notice:
本说明书有关数据是在标准条件下取得,实际使用时,环境条件可能与之略有不同,以上数据如有改变,以本公司最新说明书为准,恕不另行通知。
All information in this product data sheet is based on standard conditions and slight variation may occur with different conditions. All information in our company is subject to change without notice.